2 posts • Page 1 of 1
I have been designing with BobCad for a couple years. I cut all parts on my KFLOPS-based mill using Kmotion. I recently commissioned the folks at BobCad to write a custom post-processor for Kmotion. I have verified that it works with several of my models and attached it here to share with any Kmotion users who want it. The only operation which I found that does not yet operate correctly is the G87 cycle which they will resolve. If you find any other issues please let me know and I will pass on to BobCad to add to my ticket before they close it out. You need to change the file extension from .TXT to .BCPST before it will work.
- Custom Kflops-Dynomotion.txt
- (28.18 KiB) Downloaded 15 times