6 axis wire edm

[TomKerekes]

Hi Guilherme,

If KFLOP can not communicate to KMotionCNC then you can't have KFLOP send an MDI command to KMotionCNC. You will have to do whatever you need to do entirely within KFLOP.

[gui_marchioro]

It does makes sense.

Thanks Tom.

Sincerely,
Guilherme

[gui_marchioro]

Hello,

Just to make sure...

The WATCHDOG_DELAY defined in the example WatchdogStatusRequests.c as 5.0 can be set to any desired positive value without problems, right?

Sincerely,
Guilherme

[TomKerekes]

Hi Guilherme,

Yes it can, but realize that Windows is not a real time operating system. On rare occasions Windows/PC/USB may "freeze" momentarily. That is after all the whole purpose of KFLOP is to provide guaranteed deterministic real-time response so the PC doesn't have to. How long the worst case "freeze" will be depends on many things. So setting to less than around 1 second can run the risk of tripping the watch dog even when things are operating "normally".

HTH

[Rasta]

hi Tom;
can you please tell me if its possible to edit the IDC_Bplus , IDC_Bminus , buttons so the arrow points in the same direction than the Z axis? instead of pointing left and right?
regards
Mariano

[TomKerekes]

Hi Mariano,

Yes use the Screen Editor.