Hi Tom,
Is there a way to set KMotionCNC to boot up using units of inches? Everytime I start the program it starts in units of mm. Thanks Marlon

Thanks Tom, the inch.set file did the trick. Marlon

--- In DynoMotion@yahoogroups.com, Tom Kerekes <tk@...> wrote:
>
> Hi Marlon,
>  
> See the Setup File:
>  
> http://www.dynomotion.com/Help/KMotionCNC/ToolSetupScreenFiles.htm#Setup_File
>  
> There is also an included example called INCHES.SET
>  
> TK
>
>
> --- On Sun, 6/26/11, Marlon <roller218@...> wrote:
>
>
> From: Marlon <roller218@...>
> Subject: [DynoMotion] KMotionCNC default units
> To: DynoMotion@yahoogroups.com
> Date: Sunday, June 26, 2011, 1:06 PM
>
>
>  
>
>
>
> Hi Tom,
> Is there a way to set KMotionCNC to boot up using units of inches? Everytime I start the program it starts in units of mm. Thanks Marlon
>