Kanalog 1.0 Hardware
| Parameter | Specification |
|---|---|
| Analog | |
| DAC Outputs | (8) +/- 10V @ 10ma, recommended load >2Kohm 12 bit - update rate 11.1KHz all 8 channels |
| ADC Inputs | (8) +/- 10V 100Kohm input Impedance 12 bit - update rate 11.1KHz all 8 channels |
| Optos | |
| Opto Isolated Outputs | (8) Max differential voltage 80V 25ma |
| Opto Isolated Inputs | (8) 3-24V input, internal 10KOhm series resistor |
| Differential | |
| Differential Input Receivers | (16) ANSI TIA/EIA-422-B, ANSI TIA/EIA-423-B +/-7V common mode range, 200mv sensitivity Internal 470ohm termination |
| Relay Drivers | |
| N channel FET Switches | (8) 24V @ 1 Amp max Open Drain switches to ground |
| Digital I/O | |
| GPIO - LVTTL | (8) Outputs Source/Sink 12ma (8) Inputs LVTTL, 3.3V 1µa max |
| ±15V | |
| On-board DC-DC Generator | 2 Watts (70ma each supply) |
| RS232 | |
| Driver/Receiver | EIA/TIA-232-F |
| Terminal Strips | |
| Screw Terminals | 112 Pluggable Screw Terminals (7) x 16 pin 5mm pitch |
| Watchdog | |
| Charge Pump | DSP communication enables (1) Relay Driver, FET Switch 24V @ 1A |
| Logic Supply | |
| Voltage | +5V ±10% |
| Typical Current | 0.5 A |
| Environment | |
| Operating Temperature | 0-40º C |
| Storage Temperature | 0-40º C |
| Humidity | 20-90% Relative Humidity, non-condensing |
| Dimensions | |
| Length | 8.5 inches (216 mm) |
| Width | 7.0 inches (178 mm) |
| Height | 0.75 inches (19 mm) |
| Green | |
| RoHS | Compliant |