Importing tooltable in KMotionCNC 4.35a causes a crash of the application

Moderators: TomKerekes, dynomotion

Post Reply
jossmilde
Posts: 1
Joined: Thu Dec 27, 2018 1:36 pm

Importing tooltable in KMotionCNC 4.35a causes a crash of the application

Post by jossmilde » Thu Dec 27, 2018 2:34 pm

Hello,

When I hover over the tool field in KMotionCNC the application crashes.
I recently updated KMotionCNC from 4.34a to 4.35a.
I copied all settings including my old tool table into C:\KMotion435a\KMotion\Data.
I had a few comments in my tool old tool table, after removing them everything works fine.
I have attached my old and new tool table for reference, maybe someone can find out what's wrong with the old table.

Jos
You do not have the required permissions to view the files attached to this post.

User avatar
TomKerekes
Posts: 398
Joined: Mon Dec 04, 2017 1:49 am

Re: Importing tooltable in KMotionCNC 4.35a causes a crash of the application

Post by TomKerekes » Thu Dec 27, 2018 8:40 pm

Hi Jos,

Thanks for reporting the bug. The issue has to do with the Tool Tip message being greater than 80 characters. With your comment and offsets the Tool Tip is:

Tool 1 17mm schrobfrees Slot:1 ID:1 Length:30.1660 Diam:17.2500 X offset:-107.1700 Y offset:291.8400

Here is a Patch for Version 4.35a that should solve the problem. Copy it to your KMotion\Release directory.
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply