PID Settings for KNozz Board

Moderators: TomKerekes, dynomotion, sfzeller

Post Reply
User avatar
AmitKumar171
Posts: 2
Joined: Tue Feb 20, 2018 7:35 am
Location: India
Contact:

PID Settings for KNozz Board

Post by AmitKumar171 » Thu Jun 28, 2018 7:39 am

Hi Tom,

I am using Knozz board connected with kflop board.

I have connected thermistor Semitec 104GT2 100K ohm thermistor.

When is set the temperature of 200 degrees using m code i am not getting exact temperature. as you said it is 1degree accurate.

How to make it temperature and ADC count graph value accurate. ?

Or i have studied PID temperature control used by arduino board. Proportional Integrative Derivative (PID) Based temperature control is accurate but it is not available with current Knozz Board.

https://www.eurotherm.com/pid-control-made-easy

Above link explains PID based temperature control.

How to implement PID settings into Knozz Board.

Waiting for positive response.


Thank you

AMIT KUMAR
Thank You

AMIT KUMAR
(+91-8952917319)

User avatar
TomKerekes
Posts: 104
Joined: Mon Dec 04, 2017 1:49 am

Re: PID Settings for KNozz Board

Post by TomKerekes » Thu Jun 28, 2018 4:50 pm

Hi Amit,

You asked the same question here
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply