adding 0.0055 when zeroing on Kmotion

Moderators: TomKerekes, dynomotion, sfzeller

Post Reply
zamfir
Posts: 2
Joined: Mon Jan 22, 2018 3:50 am

adding 0.0055 when zeroing on Kmotion

Post by zamfir » Sun Jun 03, 2018 10:17 pm

Howdy,

This does not happen all the time maybe about half the time.

When using Kmotion, I will set up a part using zero probe and then on the appropriate axis hit the zero button.
many times it goes to 0.0000 as one would expect. Other times it sets to 0.0055. Once it does this, the only way to get it to read zero is to use the set button and type in -0.0055. Then display reads 0.0000. I can not seem to find the magic sauce that causes this to happen..or the magic sauce to make it never happen. It has done this on older revision and hoped upgrading to the newest would take care of it. It still happens about 1/4 to 1/2 of the time.
Not a big deal but annoying.

Anyone else experiencing this? What can I do to make it cooperate.

Thanks!
Eric from Colorado

User avatar
TomKerekes
Posts: 84
Joined: Mon Dec 04, 2017 1:49 am

Re: adding 0.0055 when zeroing on Kmotion

Post by TomKerekes » Sun Jun 03, 2018 10:50 pm

Hi Eric,
I will set up a part using zero probe and then on the appropriate axis hit the zero button.
What do you mean by this?

Does it involve a C Program?

If so is the C Program configured for Exec/wait/Sync ?

Does the C Program adjust by 0.0055 for the probe size?

Regards
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply