Move using Machine coordinates?

Moderators: TomKerekes, dynomotion

Post Reply
larryjamessmith
Posts: 10
Joined: Mon Dec 23, 2019 9:18 pm

Move using Machine coordinates?

Post by larryjamessmith » Sun Feb 02, 2020 11:29 pm

Is there a call to move using machine coordinates directly? I can compute a destination using the workspace coordinates and all offsets, but a simple "moveMachine" operation would be nice. This would be good when making tool changes or setup changes relative to absolute machine locations. If not already available I will write a function to do this...

Thanks,
Larry

User avatar
TomKerekes
Posts: 789
Joined: Mon Dec 04, 2017 1:49 am

Re: Move using Machine coordinates?

Post by TomKerekes » Mon Feb 03, 2020 4:38 pm

Hi Larry,

It seems this is a duplicate of this.
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply