Kflop and other hardware revisions

[MadTooler]

I was wondering if there is a list/documentation of Dynomotion hardware versions/revisions and their relative changes. I looked but failed to find them.

While it would be good to know for all components, I have a need to know about the kflop v1.1 to v1.3. I did see in some other posts there is a filter cap added from v1.2 to v1.3, and that software wise 1.1 is compatible with 1.3, but are there any other significant variations that should be noted?

Thanks

[TomKerekes]

KFLOP Rev 1.2 changed a resistor between 5V and the 3.3V regulator from 1Ohm to 0.1Ohm which could be a problem in systems with a lot of 3.3V usage and a lower voltage 5V supply.

[MadTooler]

Thanks, Tom.

Any other functional or performance differences between rev 1.1 and 1.3?

My initial reason for asking was because I was considering grabbing an older rev 1.1 I saw up for sale and possibly installing it on an old emco mill I just got. For the asking price, I am not sure it is worth playing with a used kflop that is over 12 years old vs. buying another new one from you. Beyond that, I thought I and others might need to know any functional differences, and maybe dates of initial release of your hardware, under varying cases.

[TomKerekes]

Here are the release dates for the KFLOP Revisions

1.1 01/2008
1.2 06/2012
1.3 02/2014

HTH

[MadTooler]

Thank you!

Have a good one.