Basic XY Screw Mapping - Geo Table

Moderators: TomKerekes, dynomotion

User avatar
Posts: 1560
Joined: Mon Dec 04, 2017 1:49 am

Re: Basic XY Screw Mapping - Geo Table

Post by TomKerekes » Fri Jul 23, 2021 4:49 pm

Hi MadTooler,
I know I could use the current Geo Correction for now, but in the future I will not be able to also use the Geo Correction for work and part correction/alignments.
Both could theoretically be combined into one Correction Table. But I agree that might be complicated especially if at different grid spacings.

I think this is actually the most efficient. Once the tables are combined the data only needs to have one table applied to it.

It is also forcing me to burden the system with 245 x 245 instead of 245 x 2 (one for x and one for y).
Probably not a significant consideration.

I need to look back, but I think I would also need to change "m_MotionParams.MaxLinearLength" to match the 0.2" and recompile anyway.
I think that is correct.

Tom Kerekes
Dynomotion, Inc.

Post Reply