Hello , Sir
I have some question. I want to control stepping motor with motor drive and Kogna controller. How to control stepping motor by Command in terminal.
My motor can move by click move button in Step Response window but it cannot move by command Move0 = 10000 (I used Axes 0 for my motor) in Console window. How can i fix this problem?
Thank you
How to control stepping motor by Command in terminal
Moderators: TomKerekes, dynomotion
- TomKerekes
- Posts: 2636
- Joined: Mon Dec 04, 2017 1:49 am
Re: How to control stepping motor by Command in terminal
Is the axis configured and enabled?
Is the Destination already at 10000?
You might try a MoveRel command.
Is the Destination already at 10000?
You might try a MoveRel command.
Regards,
Tom Kerekes
Dynomotion, Inc.
Tom Kerekes
Dynomotion, Inc.