Hello . We assembled the machine and run RTCP in KmotionCnc, did automatic tool measurement, everything works, but there is a problem when moving from angle to angle of the rotary axis in RTCP mode G1B90F500, the position of the tool tip floats within 1-2 mm. With what it can be connected?
My machine -[youtube]watch?v=d8H77a1FzKg[/youtube]
Kinematics 5Axis Gimbal CB RTCP
Moderators: TomKerekes, dynomotion
- TomKerekes
- Posts: 2529
- Joined: Mon Dec 04, 2017 1:49 am
Re: Kinematics 5Axis Gimbal CB RTCP
It seems you are double posting questions. Please see my response in cnczone.
Regards,
Tom Kerekes
Dynomotion, Inc.
Tom Kerekes
Dynomotion, Inc.