PID Settings for KNozz Board

Moderators: TomKerekes, dynomotion

Post Reply
AmitKumar171
Posts: 134
Joined: Tue Feb 20, 2018 7:35 am
Location: India

PID Settings for KNozz Board

Post by AmitKumar171 » Thu Jun 28, 2018 7:39 am

Hi Tom,

I am using Knozz board connected with kflop board.

I have connected thermistor Semitec 104GT2 100K ohm thermistor.

When is set the temperature of 200 degrees using m code i am not getting exact temperature. as you said it is 1degree accurate.

How to make it temperature and ADC count graph value accurate. ?

Or i have studied PID temperature control used by arduino board. Proportional Integrative Derivative (PID) Based temperature control is accurate but it is not available with current Knozz Board.

https://www.eurotherm.com/pid-control-made-easy

Above link explains PID based temperature control.

How to implement PID settings into Knozz Board.

Waiting for positive response.


Thank you

AMIT KUMAR
Thank You

AMIT KUMAR

User avatar
TomKerekes
Posts: 2529
Joined: Mon Dec 04, 2017 1:49 am

Re: PID Settings for KNozz Board

Post by TomKerekes » Thu Jun 28, 2018 4:50 pm

Hi Amit,

You asked the same question here
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply