Page 1 of 1

Saving of Work Offsets

Posted: Sun May 20, 2018 11:41 am
by EondeK
Hi

Which command can I use to save the parameters stored in the Work/Fixture offset table (G54, G55, etc).

Regards

Re: Saving of Work Offsets

Posted: Mon May 21, 2018 6:17 pm
by TomKerekes
Hi EondeK,

There isn't a command to explicitly save the offsets. But there is a "Save Always" option on the Edit Fixture Dialog that will automatically save the offsets to disk no matter how they are changed. Does this work for you?

SaveAlways.png

Re: Saving of Work Offsets

Posted: Tue May 22, 2018 8:20 pm
by EondeK
Thanks, this should do it.

Re: Saving of Work Offsets

Posted: Mon May 28, 2018 5:48 am
by EondeK
Hi Tom

I checked and on the version I have, the Save Always tick box is not there. How do I add that?

Regards

Re: Saving of Work Offsets

Posted: Wed May 30, 2018 3:55 pm
by dynomotion
The "Save Always" option was added with version 3.34f. You can download the latest test release here:
http://www.dynomotion.com/wiki/index.ph ... are_Topics