Saving of Work Offsets

Moderators: TomKerekes, dynomotion

Post Reply
EondeK
Posts: 14
Joined: Thu May 17, 2018 3:29 pm

Saving of Work Offsets

Post by EondeK » Sun May 20, 2018 11:41 am

Hi

Which command can I use to save the parameters stored in the Work/Fixture offset table (G54, G55, etc).

Regards

User avatar
TomKerekes
Posts: 1186
Joined: Mon Dec 04, 2017 1:49 am

Re: Saving of Work Offsets

Post by TomKerekes » Mon May 21, 2018 6:17 pm

Hi EondeK,

There isn't a command to explicitly save the offsets. But there is a "Save Always" option on the Edit Fixture Dialog that will automatically save the offsets to disk no matter how they are changed. Does this work for you?

SaveAlways.png
Regards,

Tom Kerekes
Dynomotion, Inc.

EondeK
Posts: 14
Joined: Thu May 17, 2018 3:29 pm

Re: Saving of Work Offsets

Post by EondeK » Tue May 22, 2018 8:20 pm

Thanks, this should do it.

EondeK
Posts: 14
Joined: Thu May 17, 2018 3:29 pm

Re: Saving of Work Offsets

Post by EondeK » Mon May 28, 2018 5:48 am

Hi Tom

I checked and on the version I have, the Save Always tick box is not there. How do I add that?

Regards

dynomotion
Site Admin
Posts: 12
Joined: Fri Nov 24, 2017 8:22 pm

Re: Saving of Work Offsets

Post by dynomotion » Wed May 30, 2018 3:55 pm

The "Save Always" option was added with version 3.34f. You can download the latest test release here:
http://www.dynomotion.com/wiki/index.ph ... are_Topics

Post Reply