plasma cutting machine

Moderators: TomKerekes, dynomotion

Post Reply
irmad
Posts: 47
Joined: Sun Jun 07, 2020 1:39 pm

plasma cutting machine

Post by irmad » Thu Jan 20, 2022 8:14 am

hello,
now i want to make a plasma cutting machine. what products from dynomotion should I buy? certainly KFLOP and there are other additions.

User avatar
TomKerekes
Posts: 2527
Joined: Mon Dec 04, 2017 1:49 am

Re: plasma cutting machine

Post by TomKerekes » Thu Jan 20, 2022 5:17 pm

That would depend on your design.
Regards,

Tom Kerekes
Dynomotion, Inc.

irmad
Posts: 47
Joined: Sun Jun 07, 2020 1:39 pm

Re: plasma cutting machine

Post by irmad » Sat Jan 22, 2022 9:34 am

I need 3 axis, X Y Z. plan X and Y using stepper motor Nema 34, and Y I'm not so sure, what's your suggestion for Z axis about motor? do they all have to be the same? then what board should I buy?

User avatar
TomKerekes
Posts: 2527
Joined: Mon Dec 04, 2017 1:49 am

Re: plasma cutting machine

Post by TomKerekes » Sat Jan 22, 2022 5:19 pm

If you obtain Step/Direction Motor Drivers those can usually be driven directly by KFLOP.

If you need to input analog voltages such as Torch Voltage you might add Kanalog.

If you need more isolated IO you might add one or more Konnects.

Motors don't need to be the same.
Regards,

Tom Kerekes
Dynomotion, Inc.

irmad
Posts: 47
Joined: Sun Jun 07, 2020 1:39 pm

Re: plasma cutting machine

Post by irmad » Tue Apr 12, 2022 7:53 am

is there an update for the kmotionCNC software, sir?

User avatar
TomKerekes
Posts: 2527
Joined: Mon Dec 04, 2017 1:49 am

Re: plasma cutting machine

Post by TomKerekes » Tue Apr 12, 2022 5:12 pm

Latest Test Release is 4.35f
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply