The program for probe and toolsetter

Moderators: TomKerekes, dynomotion

Post Reply
Alexanders
Posts: 33
Joined: Wed May 03, 2023 12:54 am

The program for probe and toolsetter

Post by Alexanders » Sat Apr 27, 2024 11:45 am

It's time to connect probe and toolsetter. What examples can you recommend for working with them?
I found and started studying with an example \KMotion5.3.0\PC VC Examples\KMotionCNC\Screens\Probe_JB_Stig. However, these examples only use working with probe, without toolsetter. I would really like to find a complete mutual operation of these devices.
I will be very grateful, thank you!

User avatar
TomKerekes
Posts: 2610
Joined: Mon Dec 04, 2017 1:49 am

Re: The program for probe and toolsetter

Post by TomKerekes » Sat Apr 27, 2024 7:48 pm

That depends on your job setup and use of offsets. The example ToolTableSet.c will set a tool table length such that the GCode DRO will read 0 with the tool tip touching the setter. Motion to probe the tool tip to the setter would need to be added for your tool setter.

You might also read this Thread.
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply