Page 1 of 1

Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 6:35 pm
by Druid_ON
Tom,

Please review my "Proposed Kanalog - Hitachi VFD Circuit" and let me know what changes I should make.
I have attached a copy of the circuit and some VFD info which may apply.
Unfortunately I am a complete neophyte and will need to be spoon fed!
Many thanks for your help and patience!

Keith G

Re: Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 6:38 pm
by TomKerekes
Hi Keith,

I don't see any attachments.

Re: Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 6:56 pm
by Druid_ON
They loaded on my end but with a yellow triangle symbol under status title. Do they load only as doc. files. PDF nor BMP files seem to upload.
Thanks

Keith

Re: Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 8:02 pm
by dynomotion
You should be able to attach both PDFs as well as BMP files. I'm not sure what the yellow triangle means, do you also get an error message?

Re: Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 8:24 pm
by Druid_ON
Tom,

Getting an http error! Super slow loading.
If I drag a BMP file to the message box I get an improper file extension message.
Could I try to post the info on CNCZone but I hate to duplicate a posting.
I will try to post another day on the Dynomotion forum.

Keith G

Re: Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 8:49 pm
by Druid_ON
Tom,
I apologize for extra work needed to open zip files but its the only way I could send them.

Keith

Re: Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 9:28 pm
by TomKerekes
Hi Keith,

I hadn't realized *.bmp files weren't allowed. They should be allowed now. But *.pdf and *png are/were supported so we're not sure why you had an issue.

Anyways regarding Proposed Circuit: The Kanalog Switch Outputs can only switch to GND (sink). In your configuration (Source), the pins need to be pulled to +24V to activate. But if you change the Short Bar to Sinking as shown in section 4-8 it should then work. An other option would be to use Kanalog Opto Outputs that can source or sink current.

The Analog connection seems correct.

Re: Kanalog - Hitachi WJ200 VFD Circuit Question

Posted: Thu Mar 21, 2019 9:53 pm
by Druid_ON
Tom,

Thank you for your speedy reply and clear direction.
I will follow your suggestions and get on with testing my VFD/spindle motor.

Keith