Kanalog jp13

Moderators: TomKerekes, dynomotion

Post Reply
Rasta
Posts: 20
Joined: Fri Mar 08, 2019 8:24 pm

Kanalog jp13

Post by Rasta » Thu Sep 16, 2021 8:34 am

Hi;
I’m trying to turn on a AC SSR , directly from the Kanalog JP 13 Opto_0_plus ,and Opto_0_neg , the SSR
Dc input is from 3v to 30vdc .
Can you please tell me is it’s possible? And if so , what is the voltage that I should get between Opto_0_plus and Opto_0_neg..
Thank you
Mariano

User avatar
TomKerekes
Posts: 1535
Joined: Mon Dec 04, 2017 1:49 am

Re: Kanalog jp13

Post by TomKerekes » Thu Sep 16, 2021 4:09 pm

Mariano,

Opto Outputs do not supply any Voltage. They operate like a switch. You will need some voltage source (ie 24V supply). Then wire it as a circuit as you would with a battery, light bulb, and switch.

HTH
Regards,

Tom Kerekes
Dynomotion, Inc.

Rasta
Posts: 20
Joined: Fri Mar 08, 2019 8:24 pm

Re: Kanalog jp13

Post by Rasta » Thu Sep 16, 2021 11:08 pm

ThanksTom , for the prompt answer
Does it means that for voltage source I can use the Kanalog 5v and ground pins to supply the voltage source? If so please can you please provide connection guidance?
Regards
Mariano

User avatar
TomKerekes
Posts: 1535
Joined: Mon Dec 04, 2017 1:49 am

Re: Kanalog jp13

Post by TomKerekes » Thu Sep 16, 2021 11:35 pm

Hi Mariano,

Yes. Connect:
+5V to an Opto Output +
Opto Output - to the SSR Control Input +
SSR Control Input - to KFLOP GND
Regards,

Tom Kerekes
Dynomotion, Inc.

Rasta
Posts: 20
Joined: Fri Mar 08, 2019 8:24 pm

Re: Kanalog jp13

Post by Rasta » Fri Sep 17, 2021 10:21 pm

Thank you Tom,
You are a Champ!
Regards
Mariano

Post Reply