Encoder AB Z

Moderators: TomKerekes, dynomotion

Post Reply
TechyMind
Posts: 2
Joined: Sun May 12, 2024 10:53 am

Encoder AB Z

Post by TechyMind » Sun May 12, 2024 11:58 am

Hello

I am about to build a machine with servo motors so I need the encoder feedback.
I see kflop/kogna receive quadrature A and B but I would also need the Z signal.
Is that possible to o configure that?

Thanks

User avatar
TomKerekes
Posts: 2610
Joined: Mon Dec 04, 2017 1:49 am

Re: Encoder AB Z

Post by TomKerekes » Mon May 13, 2024 12:23 am

Hi Techy,

Yes Index pulses are handled in software so any input can be used. See also here.
Regards,

Tom Kerekes
Dynomotion, Inc.

TechyMind
Posts: 2
Joined: Sun May 12, 2024 10:53 am

Re: Encoder AB Z

Post by TechyMind » Mon May 13, 2024 6:47 pm

Thank you Tom,

I’m always impressed how you are dedicated.

That’s one of the good point for I wish to buy your controller card.

Julien

Post Reply