the breakout board is shown in DMM's system diagram looking like you add the controller after this point (see pic). In the interests of a cleaner setup I wouldn't like to add anything unnecessary.
Thanks again, Mick
Deciding if Kflop is for me
Moderators: TomKerekes, dynomotion
Re: Deciding if Kflop is for me
Hey Tom,
the breakout board is shown in DMM's system diagram looking like you add the controller after this point (see pic). In the interests of a cleaner setup I wouldn't like to add anything unnecessary.
I most likely do have opto isolation, however it will be a part of the Mitsubishi system currently fitted. I will purchase the Konnect board but I would like to dodge a second S&H charge obviously.
Thanks again, Mick
the breakout board is shown in DMM's system diagram looking like you add the controller after this point (see pic). In the interests of a cleaner setup I wouldn't like to add anything unnecessary.
I most likely do have opto isolation, however it will be a part of the Mitsubishi system currently fitted. I will purchase the Konnect board but I would like to dodge a second S&H charge obviously.
Thanks again, Mick