+/-10V and an old brushed DC motor

Moderators: TomKerekes, dynomotion

Post Reply
IVAN
Posts: 1
Joined: Wed Feb 22, 2023 9:47 pm

+/-10V and an old brushed DC motor

Post by IVAN » Fri Feb 24, 2023 4:49 pm

I was looking for a CNC controller to renew/retrofit an old foam cutting machine.
I wanted to keep original DC motors to save some money. Searching the WEB
I found Dynomotion's KFLOP board. Together with KAnalog board you get +/-10V
output and encoder feedback, so you can use any new DC controller and tune/adapt an old brushed DC motor with no problem.

Dynomotion System gives you powerful hardware and software and what is
most important EXCELLENT SUPPORT! Of course, at the beginning you need to put in quite a bit
of effort, but are rewarded later with great PLC/CNC/servo controller. A huge number
of all kind of samples are very helpful. Not to forget great support that you get from
Tom Kerekes. He was answering my questions almost the same day. Sometimes I was wondering
when Tom sleeps. (If he sleeps at all - a joke)

User avatar
TomKerekes
Posts: 2604
Joined: Mon Dec 04, 2017 1:49 am

Re: +/-10V and an old brushed DC motor

Post by TomKerekes » Fri Feb 24, 2023 6:58 pm

Hi Ivan,

Thanks for the kind words and your patience.

Consider leaving us a Review.
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply