Kmotion Simulation

Moderators: TomKerekes, dynomotion

Post Reply
Mbarabasz
Posts: 2
Joined: Wed Oct 19, 2022 11:36 pm

Kmotion Simulation

Post by Mbarabasz » Wed Nov 09, 2022 12:15 am

Hi folks,
I'm new to this environment. Can I run Kmotion CNC in simulation mode? I have the Kmotion SW installed on my laptop but it's not connected to a Kflop controller. I was hoping to get some stick time in simulate mode to give me a better understanding of the product.

User avatar
TomKerekes
Posts: 2529
Joined: Mon Dec 04, 2017 1:49 am

Re: Kmotion Simulation

Post by TomKerekes » Wed Nov 09, 2022 3:25 pm

Run KMotionCNC and check simulate.
Regards,

Tom Kerekes
Dynomotion, Inc.

Mbarabasz
Posts: 2
Joined: Wed Oct 19, 2022 11:36 pm

Re: Kmotion Simulation

Post by Mbarabasz » Thu Nov 10, 2022 8:01 pm

Ah, finally found it. thanks.

Post Reply