lag in the DAC spindle output

Moderators: TomKerekes, dynomotion

Post Reply
Posts: 325
Joined: Fri Mar 15, 2019 4:07 pm
Location: southern oregon

lag in the DAC spindle output

Post by turbothis » Tue Apr 30, 2024 5:05 pm

so if i start the spindle at half speed 700 rpm
it will ramp right up. no trouble

now when i move the slider bar down in rpm, it is real slow even though the DAC is maxed in the opposite direction to slow the spindle :?
then if i hit "OFF" it takes about 2 second stop stop outputting the DAC

why is this?
i am feeling like there is a lot happening other than my commands
speed.JPG (14.12 KiB) Viewed 91 times

Post Reply