Position counts to user units?

Moderators: TomKerekes, dynomotion

Moray
Posts: 101
Joined: Thu Apr 26, 2018 10:16 pm

Re: Position counts to user units?

Post by Moray » Tue Dec 11, 2018 8:38 pm

Tom, so I've got enough code to reverse until the probe clears, however as you've mentioned using SetFROTemp is less than ideal (moving at 5IPM it pushes my test box about 10thou before reversing).

I've switched to using SetFROwRateTemp(), and set a randomly selected time of 0.1, which appears to work well, but random figures are rarely good long term. How should this time ideally be calculated?

User avatar
TomKerekes
Posts: 474
Joined: Mon Dec 04, 2017 1:49 am

Re: Position counts to user units?

Post by TomKerekes » Tue Dec 11, 2018 9:21 pm

Hi Moray,

You might try Time = Probe Speed/axis Acceleration
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply