Dynomotion Forum

I'm finding that when I zero one of my axes, the change is saved to my emc.var file, so my G92 coordinates are wrong the next time I start KMotionCNC. I haven't noticed that behavior in the past. Is there a setting that is causing KMotionCNC to alter the emc.var file?

Is it because I have "Save always" checked in the "Edit fixture offsets" dialog? I've never used that dialog, so I'm not sure how that setting would have changed.

Hi amowry,

Is it because I have "Save always" checked in the "Edit fixture offsets" dialog?

yes

I've never used that dialog, so I'm not sure how that setting would have changed.

idk. But the default is set true, so if the settings were lost/reset that might be the explanation.

Okay, thanks Tom!