I am getting some warnings when trying to run G code generated by AlphaCam.
One of them is that when G2 or G3 command uses I and J parameters, KMotionCNC shows the following warning. The same does not occurs if instead of I, and J, the parameter R is used.
Another problem is with respect to tool compensation (G41 and G42). For instance, when I try to execute the G code presented below I get an error saying "Concave corner with cutter radius comp" on line N80. What I intent to draw with the code below is just a circle with 9 mm radius, using a tool that has 14 mm diameter.
How can I overcome these problems? Is there a recommended post processor for AlphaCam?
Code: Select all
N10 G40 G49 N20 G54 N30 G0 X0 Y0 Z0 N40 M3 S1000 N50 G43 H1 N60 G41 D1 N70 Y-9 N80 G3 Y9 R9 N90 Y-9 R9 N100 G1 Y0 N110 M30