Fourth axis

Moderators: TomKerekes, dynomotion

Post Reply
SSN720
Posts: 2
Joined: Sat Aug 14, 2021 2:11 am

Fourth axis

Post by SSN720 » Sat Aug 14, 2021 12:38 pm

Can’t get second kstep to operate fourth axis

User avatar
TomKerekes
Posts: 2529
Joined: Mon Dec 04, 2017 1:49 am

Re: Fourth axis

Post by TomKerekes » Sat Aug 14, 2021 12:47 pm

Please put more effort into your question. Describe your system, what you are trying to do, what you have done, and what happens. Post your initialization C program.
Regards,

Tom Kerekes
Dynomotion, Inc.

SSN720
Posts: 2
Joined: Sat Aug 14, 2021 2:11 am

Re: Fourth axis

Post by SSN720 » Sat Aug 14, 2021 6:21 pm

Hooked up kflop and both steppers per dyna motion. Then nothing worked removed the 4wire jumper between ksteps and supplied outside voltage then nothing worked except rotary using x axis button. Hooked up kflop/kstep per original and left Ethernet between second kstep and kflop then x,y,z worked normally but rotary did not

User avatar
TomKerekes
Posts: 2529
Joined: Mon Dec 04, 2017 1:49 am

Re: Fourth axis

Post by TomKerekes » Sat Aug 14, 2021 9:32 pm

Hooked up kflop and both steppers per dyna motion.
Did you mean KSteps? Not steppers?

It’s Dynomotion by the way.
Then nothing worked removed the 4wire jumper between ksteps
Put those back. They are needed.
Hooked up kflop/kstep per original and left Ethernet between second kstep and kflop then x,y,z worked normally but rotary did not
Its important you tell us how things are configured as we asked. Post your Initialization C program.
Regards,

Tom Kerekes
Dynomotion, Inc.

Post Reply