Dynomotion Forum

Hello Tom, Lat week, 4 days , I had an extensive test with 3 different 3D models from 150 sq inch to 5 sq inch surface. All test performed with 3500-4000 mm/min and various Colinear and Corner Tolerance not bigger than 2-10e-3 and not smaller than 5- 10e-4. So far USB comm went smooth , therefore I ...

Hello Tom, I made adjustment upon Colinear and Corner Tolerance as suggested. Tau factor, however, is not implemented in my system. Regarding link and descriptions : I feel out-dated :) Next days I will focus on my main revenue paid-job->automation. Therefore I will refresh the info after next tests...

Hi Tom, For practical reasons I must take all information and check-them step-by-step. USB test : File mentioned -> SimpleformsCS.exe start. Error on run. Error signature : EventType : clr20r3 P1 : simpleformscs.exe P2 : 1.0.0.0 P3 : 534a05e2 P4 : kmotion_dotnet P5 : 1.0.1.0 P6 : 531ca6f7 P7 : 3b P8...

Hello Tom, Sorry -> I was expecting a large .nc file [ 4Mb ] to be refused as attach. This is why I asked for an uploaded method. My usual .nc files stay from 2 to 16 Mb. As I say before, I operate the program - after 75% of his volume, on 2 deg adjustment. Compared surfaces - identical surfaces bot...

Hi Tom, Your advice is appreciated. I check-it-up by small steps, until my models surface was smooth applying effect from : (G code generator + Facet Angle ), therefore I arrived to 0.3 deg. Below that value was small or no significant change in surface [ I check all surfaces with magnifying glasses...

Hi Tom, If G code is 'heavy small' , on certain parts of models in produce there is no use if I increase the LookForwardTime. System go to Underflow . [ i.e. from 2.5 to 5 or even 10 sec ]. I am getting fast in a position to decrease the overall speed to 1500 mm/min even the CNC play well up to 5800...