Dynomotion Forum

The JP4/6 extension card pcb for Kflop is now available. It is added to the KFlop card via the connector AUX#0 JP4 or AUX#1 JP6, which supports 10 optocoupled inputs or outputs. The opto-io's have an isolation voltage of 3750.0 volts (AC for 1 minute). The inputs can handle 5.0 to 24.0 volts with a ...

The following error was very big, when i decreased to 10mm (500, the cnts/mm is 50) i had an following error on ch0 the master/slave are ch0/ch1.

In a large gantry machine measuring 10 meters in width, I conducted a pen trace and obtained the results depicted in the accompanying images. When I drew a circle in a clockwise direction, the resulting shape appeared as an oval, with the longer diameter rotated approximately 45 degrees clockwise, a...

The JP12 extension card for Kanalog is now available. It is added to the kanalog card via the connector GPIO JP12, with 8 optocoupled inputs and 8 optocoupled outputs. The opto-io's have an isolation voltage of 3750.0 volts (AC for 1 minute). The inputs can handle 3.0 to 24.0 volts with a series res...

Hello. Im retrofiting an big flatbed plasma cutting machine, with an efective cutting area 26 x 5 m. When i try to configure the Box size in the G viewer setup, screen i noticed that more than 600 inches in the Y size box it is not showing. The size i need to put in is 260000m/25.4" = 1023" inches x...

Thank you for the quick reply. The file somehow was there, but with no data.
In the error window, it would be a good idea, to say something like "Recuired parameter missing, in file vars"
Regards.

Hello.
Any idea what this error is?
It comes when i send any gcode command from Kmotioncnc.
Version 435g.
The Kmotion console does not show anything, when this error comes.

Sometimes i put a printf in the initialisation c program, which runs in an endless loop, for debuging purposes. After i run the loop again and check the console for the outcome, i realize that the printf is runing ones every loop and the console is flooded with the debuging message. Even if the c pr...

Thank you very much.

Thank you for the reply but

assign it to the KMotionCNC Startup Action.

How do i do that?
Regards.