Dynomotion Forum

That depends on your job setup and use of offsets. The example ToolTableSet.c will set a tool table length such that the GCode DRO will read 0 with the tool tip touching the setter. Motion to probe the tool tip to the setter would need to be added for your tool setter. You might also read this Threa...

Tuning any servo is fundamentally the same, but with different response times and such. If the Spindle Drive has a excessive delay that can be problematic. Is the Drive input commanding torque or velocity? Please post Step Response Screen Plots with also your IIR Filter and Configuration settings an...

Hi Batty, Very good. But several things: #1 the Acceleration is set extremely high relative to that level of Jerk. Jerk is normally set around 10X the Acceleration value in order to to apply the full acceleration in around 0.1 seconds. With those levels of A and J it would take 200 seconds to apply ...

Very nice Noel

Correct

Hi Noel,

I believe you only have Step/Direction signals connected to the Drives which is Position with no way to control velocity. So the Drives would need to be in Position mode.

Yes it is possible.

Grounding is complex but one approach is to connect shields that are on noisy signals (Motor wiring, supply wiring, etc) with the purpose of collecting noise and preventing radiation of noise, to be connected to earth gnd away from KFLOP. If these shields are connected to the KFLOP/SnapAmp/KStep DC ...

Hi Griffin, Strange there would be so much noise with fairly low currents. SnapAmp not being isolated is it's major drawback. But this normally only becomes problematic switching 10's of Amps with multiple motors. Grounding is very complex. Maybe you could describe your grounding, earth grounding, p...

Hi Neil,

You can assign a GCode file to a button by specifying the Execute Prog Action with a file with an .ngc extension.

Remember to terminate the GCode with M30