Dynomotion Forum

Hi Eero, I can't duplicate the problem with those settings. If I code G0 X100 M30 I see a feedrate of 10.3 inches/minute which seems correct. Also if I double the KFLOP Velocity to 28000 steps/sec the feedrate doubles to 20.6 inches/minute. What are you doing and seeing? One issue is the Cnts/inch o...

Hi Eero, I can't think of why that would be. What Version are you running? Please post your Initialization file and your Trajectory planner settings. Also the GCode that shows the problem. Are you executing the C Program? You might upload the settings from KFLOP to verify the settings are actually b...

Hi Tray,

The .NET documentation is on-line here.

Hi Tray,

Maybe the required version of .NET is missing on the PC? Does the example SimpleFormsCS run?

You might read this Thread.

Hi Griffin, I was curious what you thought about the impact of placing 30KHz band-reject filter on the ground connection between the SnapAmp and KFLOP, such that switching transients don't conduct into the logic ground. Do you think this would pose any advantages? Although the switching occurs at 30...

Hi kilzilkaya, It would be nice if you explained what you are trying to accomplish. If you need these bits in another Windows App it would be better to have the app read them directly. You might look at or use the function: bool CScreen::ReadBitCached(int bit) You can get the Virtual bits individual...

The C Program Parameters must be contiguous without embedded comment lines to be imported correctly.

Try importing example \KStep\InitKStep6AxisSpindleAxis6.c to see if it imports correctly.

Hi Alexanders, No 'IF' and 'WHILE' aren't supported. But the similar functionality can be achieved with looping subroutine calls. See the example SubroutineWithConditionals.ngc shown below: G20 #100 = 5 (examples of logical operations) (result is 1 if condition is true) (result is 0 if condition is ...

Hi Noel,

Do you have the M6 Action set to Execute/wait/Sync? If not try that.

If the DAC/Spindle responds correctly then the problem is likely with the configurations/tuning. I assume there is encoder Feedback? Please post your Config/Step Response/Filter screens and Spindle Programs. One thing that may be happening is the output is limited so it can't keep up with the comman...