Dynomotion Forum

No problem Tom! Such problems should happen in order to learn! I made a VBA macro by ChatGPT that reads the table in col A = Commanded and col B = Actual and writes an inverse , interpolated table into col C (Desired Actual) and col D (Interpolated Commanded) . The macro asks for start/end/step. Pas...

Hello Tom,
The linear table should be prepared in inch unit.
I made a macro to make the corrected data after measurement. If youy want, I will share it.

Also please mention the unit in your guide/help.
Thanks & regards,

Hello Tom, I did a debug on KmotionCNC and GCodeInterpreter and found that the Z count calculation in Kinematics.cpp is based on inch unit and the linear correction table should be prepared in inch. This was the main source of error. I will check again with inch unit and inform you the result. By th...

Hi Tom, KMotion 5.4.0 Z Traveling range is 110mm. I tried for 10 days and everyday I try a different way and different measurements but result is almost same. something is wrong that I don't understand. I changed kinematics.cpp and defined an array (hard coded mesurement data) but still have problem...

I am a new user of Dynomotion boards and enjoyed a lot with the strong features. I am using Kanalog, KFlop and KStep for a scissor shape lab jack purchased from PDVCN pt-gd402: This jack is nonlinear and I need to correct it. I have tried a lot as per your instruction in below link wiki/index.php/Li...