Dynomotion Forum

It took a couple tries to get the first part to run successfully, but at least here is the first component to my operator console. I'm using a post processor from Fusion 360 to make my g-code, though I really should try to write some from scratch myself. I did the engraving with a 1/32" end mill, ot...

It's been a while since I've posted and it's exciting when things happen so I wanted to share my progress (even if it is rather slow, though that's because I've been involved in other projects - I'm still reluctant to share actual pictures since I haven't finished the operator panel). I finally made...

I wanted to just edit my post above, but oh well. Did you just mount the Genevia gear / wheel / whatever it's called straight to the gearbox? I'm seriously curious how well that works since I'm assuming that's what you did - I really want to try this - I need to get a gearbox for my servo now, that ...

Looks like you beat me to it on adding a servo to the carousel. I'm about to jump back into working on mine - I got tied up with a couple machine installations for customers (and building a compressor that can handle this addition to my shop since mine was dying - again this is more so of a product ...

I appreciate the reply and information - I was starting to think you went silent on here. I've got it mostly running (although I had almost everything mechanical disconnected, I tend to be very anxious with new code until I've tested it thoroughly), I tested the spindle motor without air - that sure...

And I just finished another project, I'm going to be busy for the next month and a half (possibly two) as I've got two more projects in the works - one machine we're working on in house and a line I'll be programming in two weeks. So it may be a bit before I switch back to working on the Fadal. I've...

It took a little bit to get back to this, I've been all over the place this week, thankfully it's mainly been for drumming up more business. Alight, it took a bit to get it to be able to move the servos. Since everything is wired and I haven't written the configuration to the KFlop yet, I'll get to ...

I went over my wiring today (at least what I had left to do for wiring up the operator panel) and finished what I needed to before I could test tomorrow. I also bit the bullet and cut and soldered a resistor on the two servo amplifier boards that weren't in current control mode (torque mode) yet, if...

I'll be back on this soon, I'm almost done with an installation and service orders I'm working on.

My second set of adapters for the signal wires (+- 10V signal cables [I could be wrong on the voltage here, I haven't verified that it operates in this range] that go to the 1010 axis cards) plugs in and a continuity test shows I have continuity up to the terminals on the servo amplifiers. Now I nee...