Dynomotion Forum

I was trying to look at this from an aerial view, keeping in mind that I had a working system that suddenly quit. I should have been more specific. It still isn't clear if the screens are synchronized with the C Program values. The Step Response Move button sets the screen values to KFLOP. If those ...

Tom, Here is my program that I was using before my KStep CH0 quit working. I replaced the KStep board with no success with getting CH0 to work, so I replaced the KFlop board too. Now I am running again with your KStep 4 axis program but not my program nor your KStep 3 axis slave. Before I had KStep ...

Tom,
Thanks for your assistance. Please see attached files.

Thanks,
Jerry

New KFlop and KStep. Using supplied KStep 4 Axis programmed supplied in the download, all 4 axis motors work independently with no issues. Using supplied KStep 3Axis with slave Axis, slave Axis does not work. Channel 1 is slaved to Channel 0. Using Step Response to move Channel 0 will move motor. Us...

Tom,
Thanks so much for your timely advice. What a simple mistake I made, I forgot to change bits in the home program. Thanks for your time!

Using KFlop, KStep, and KConnect. First start up. Axis CH2 and CH3 work with no issues, sensors work and homing is achieved. Problem is with CH0 and CH1. CH0 is master and CH1 is slaved to CH0. Step Response for CH0 and CH1 motors work fine. Sensors have all been verified and show status in KConnect...