Search found 3 matches

by scott
Fri Dec 06, 2019 9:48 pm
Forum: Miscellaneous
Topic: THC on a new Plasma build
Replies: 5
Views: 2486

Re: THC on a new Plasma build

Thanks for the quick and helpful response. I will be placing my order for new boards with Dyomotion early next week for the entire system. I look forward to the build with this kind of great assistance!
by scott
Fri Dec 06, 2019 7:13 pm
Forum: Miscellaneous
Topic: THC on a new Plasma build
Replies: 5
Views: 2486

Re: THC on a new Plasma build

I should use a board such as the THCAD from Mesa to convert from voltage to a frequency at a range of 100KHz to 1Mhz. Then bring it into an encoder input. I understand what you are saying about the dual loop control in theory, how difficult is this to implement in the kflop?
by scott
Thu Dec 05, 2019 11:16 pm
Forum: Miscellaneous
Topic: THC on a new Plasma build
Replies: 5
Views: 2486

THC on a new Plasma build

I am starting a new plasma table build. I am planning on using KmotionCNC with Kflop for the controller. All motions are DC motors with encoder feedback to two snapamp drivers. It will have 2 x motors, 1 y and 1 z motor in a typical gantry layout. I have done this before with a CNC setup, but I have...