Dynomotion Forum

Tom, You are correct, I am wiring it into an existing BLDC spindle controller system on a PM30-MV until I can afford to upgrade to a good VFD setup in the future. The 220v service is actually isolated from the control circuit by the motor controller. The current plan is to drive the forward/reverse ...

Does anyone on the forum have experience using a KBSI-240D Signal Isolator board to drive a BLDC motor controller from a DAC on the Kanalog? The wiring appears simple enough, but since I'm about to wire into a 230V inductive load through an interface card I thought I might check to see if anyone has...

Thanks for the quick response Tom.

Hello, I've recently purchased a Kflop/KAnalog combination and I'm in the process of wiring everything up. For the sake of clean wire management, I was looking at the possibility of using the Optical outs on the KAnalog for my step and direction signals that drive my stepper drivers. The drivers are...