Dynomotion Forum

Hi Tom Version V433q. Yes, it used to work without this problem. Havn't tried K motion. The machine is currently in production use and the operators aren't familiar with K motion so would be difficult to run it for any length of time. I have asked for a screen shot when it fails. It failed twice yes...

I am running a mill with a K flop, 2X snap amps and a K step. Windows 10 with Mach3. Works really well except it randomly stops with a blueish screen that's not responsive. It can do this whilst running a program, or not, and sometimes on switch on. This fault can be cleared by just unplugging the U...

Hi Tom Thanks for your speedy reply. I will say yes to the pop up and hopefully open KMotion and look at the console info. I was just concerned I might loose all the configuration data. Switched on is not a good term! The servos are not enabled before the amplifiers. The machine is on a different si...

I few years ago I modified a mill with a Kflop, Kstep, and 2 snap amps running under Mach3. It has developed a problem where I get a message saying X, Y or both axis are disabled when switched on. If you keep trying usually, eventually it will start ok and then all functions work fine. I thought the...