Dynomotion Forum

I have installed the patch and everything is now running as it should.
Thank you so much for your help again, Tom. Your support is the best!

William

Okay, here is the data folder KMotion5.3.7/KMotion/Data

Just to be sure, I have run the G code file again with this configuration and it faults.

Hi Tom I had thought we referenced the Data folder in the CNC_George_CFiles. However here is KMotion435f/Kmotion/Data. KMotion435f is the version that currently works along with our C programs in CNC_George_CFiles When we installed Kmotion 5.3.7. We have tried operating the machine with the default ...

Sorry for the confusion. The folder sent was copied, it should be the exact same as original but to be safe, here is the original folder. The init file (InitSnapAmp4axis_M1.c) is in the KFlop folder. I am not sure how you pulled up the old KStep init file reference.

StepResponse results attached:

Tom, Not sure where that file is coming from. This is my setup screen which you can see references InitSnapAmp4axis_M1.c Tool Setup - User Buttons.png Tool Setup - ToolSetup.png Here is a fragment of G code that exhibits abnormal behaviour. Shooting Board – Fences.txt The fault occurs after line N75.

Hi Tom, I have installed version 5.37 on an old computer so I can keep my machine running with 4.35f as I need. With the 5.37 install I ran a few G0 and G1 commands in the manual entry cell and there were no issues. Ran the GCode file and ended up with the same issue after a second or two. I've chec...

Thanks for the link. I have saved the file for future reference. After re-installing to 4.35f, everything is working fine again. Most of my customised program files are outside the install folder so I am using the same program files for both versions. There is a question regarding the file: KflopToK...

Hi Tom, I recently upgraded two computers that run my two CNC routers, and took the opportunity to upgrade Kmotion software from 4.35f to 5.37. Both KFlop boards were flashed with new version. I have done this with two machines. One has Kstep which works fine. My other machine has SnapAmps and I now...

Just a note to say, my upgrade is complete and have managed to sort through all issues. Everything is running smoothly.
Thank you for all your support.