Dynomotion

Group: DynoMotion Message: 5511 From: mrosenfield2 Date: 8/3/2012
Subject: Re: post processor
It appears that the best post processor is EMC2 version 1.

--- In DynoMotion@yahoogroups.com, "carlcnc" <cebcnc@...> wrote:
>
> Michael
>
> I would start with Fanuc6[might be 6m]
> I haven't used BobCad since ver 17, and that was sveral years ago
>
> Carl
>
>
> --- In DynoMotion@yahoogroups.com, "mrosenfield2" <mrosenfield@> wrote:
> >
> >
> > Tom,
> >
> > I'm almost ready to start testing some G-code on my mill. I'm going to
> > use BobCam to generate it. What post processor should I specify for
> > Kmotion CNC?
> >
> > Thanks,
> >
> > Michael
> >
>
Group: DynoMotion Message: 4435 From: mrosenfield2 Date: 3/29/2012
Subject: post processor
Tom,

I'm almost ready to start testing some G-code on my mill. I'm going to
use BobCam to generate it. What post processor should I specify for
Kmotion CNC?

Thanks,

Michael
Group: DynoMotion Message: 4437 From: carlcnc Date: 3/29/2012
Subject: Re: post processor
Michael

I would start with Fanuc6[might be 6m]
I haven't used BobCad since ver 17, and that was sveral years ago

Carl


--- In DynoMotion@yahoogroups.com, "mrosenfield2" <mrosenfield@...> wrote:
>
>
> Tom,
>
> I'm almost ready to start testing some G-code on my mill. I'm going to
> use BobCam to generate it. What post processor should I specify for
> Kmotion CNC?
>
> Thanks,
>
> Michael
>