Dynomotion

Group: DynoMotion Message: 5689 From: bradodarb Date: 9/17/2012
Subject: Setting up Multi axis from .c code only
Hello Tom,

Can I setup a multi axis system from a .c file?

Meaning all trajectory planner settings, etc...


Thanks,

Brad Murry
Group: DynoMotion Message: 5690 From: Tom Kerekes Date: 9/17/2012
Subject: Re: Setting up Multi axis from .c code only
Hi Brad,
 
No.  The Trajectory Planner runs in the PC rather than in KFLOP so it is normally configured by the PC App (KMotionCNC or equivalent).
  
Regards
TK
 

Group: DynoMotion Message: 5693 From: Brad Murry Date: 9/18/2012
Subject: Re: Setting up Multi axis from .c code only

Hello Tom, 

 

That makes sense.  I was looking down the wrong end of the barrel I suppose.

 

I always like to ask before I assume, thanks for your time.

 

-Brad Murry

 

 

From: DynoMotion@yahoogroups.com [mailto:DynoMotion@yahoogroups.com] On Behalf Of Tom Kerekes
Sent: Monday, September 17, 2012 10:03 PM
To: DynoMotion@yahoogroups.com
Subject: Re: [DynoMotion] Setting up Multi axis from .c code only

 

 

Hi Brad,

 

No.  The Trajectory Planner runs in the PC rather than in KFLOP so it is normally configured by the PC App (KMotionCNC or equivalent).

  

Regards

TK

 

 

From: bradodarb <bradodarb@...>
To: DynoMotion@yahoogroups.com
Sent: Monday, September 17, 2012 9:28 PM
Subject: [DynoMotion] Setting up Multi axis from .c code only

 

 

Hello Tom,

Can I setup a multi axis system from a .c file?

Meaning all trajectory planner settings, etc...

Thanks,

Brad Murry