Does KMotion not support using G10 L1 to write the tool table? Is there an alternative way of doing this, or can the tool table only be modified by editing the file and re-loading it?
Regards,
Ray L.
Group: DynoMotion
Message: 3456
From: brad murry
Date: 1/26/2012
Subject: Re: KMotion Does Not Support G10 L1?
There are methods in the .net API to get and set tool values. These have been tested as well.
-Brad Murry
From:
himykabibble Sent:
1/26/2012 8:45 AM To:
DynoMotion@yahoogroups.com Subject:
[DynoMotion] KMotion Does Not Support G10 L1?
Does KMotion not support using G10 L1 to write the tool table? Is there an alternative way of doing this, or can the tool table only be modified by editing the file and re-loading it?
