Dynomotion

Group: DynoMotion Message: 14288 From: Moray Cuthill Date: 12/18/2016
Subject: Implementing time delays
I'm working on the tool changer sequence for my mill, and there are a few places where to match the original control, I need to implement 40 and 500 millisecond delays.

Is there any easy way to implement delays involving milliseconds?

Thanks,
Moray
Group: DynoMotion Message: 14289 From: moray_cuthill Date: 12/18/2016
Subject: Re: Implementing time delays

OK, ignore that.

Just realised time_sec returns a double, so fractional seconds is possible.


Moray

Group: DynoMotion Message: 14291 From: Tom Kerekes Date: 12/18/2016
Subject: Re: Implementing time delays

Hi Moray,

You might use:

Delay_sec(0.04);

and

Delay_sec(0.5);

Regards
TK


On 12/18/2016 3:37 PM, Moray Cuthill moray.cuthill@... [DynoMotion] wrote:
 
I'm working on the tool changer sequence for my mill, and there are a few places where to match the original control, I need to implement 40 and 500 millisecond delays.

Is there any easy way to implement delays involving milliseconds?

Thanks,
Moray