Known KMotionCNC CAD/CAM Post Processors

From Dynomotion

Revision as of 14:28, 13 March 2018 by TK (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Mechsoft

Hi Tom,
 
After much digging, I did find a post processor file in the Freemill site and it seems to work! 
 
Just an FYI:
The (freemill) instructions installing it were not accurate so if you run into this in the future the processor is downloaded at :
 
And then the file is installed into
C:\ProgramData\MecSoft Corporation\VisualCAM 2014\Posts\MILL
 
Thanks for your rapid reply!
 
Troy

AutoDesk Fusion 360

See this post
Also this post
Alexander (Александр Украинец) contributed two Posts.  One for Mill and one for Lathe (the .txt extension should be removed)
Fusion360_KFLOP_Turning_Rev2.cps.txt (Added thread cutting G32)