Difference between revisions of "Known KMotionCNC CAD/CAM Post Processors"

From Dynomotion

Jump to: navigation, search
(Dolphin CAD/CAM)
m (Dolphin CAD/CAM)
 
Line 50: Line 50:
  
 
==<span style="font-size: 11pt; font-family: 'Calibri','sans-serif'; color: #000000;">Dolphin CAD/CAM</span>==
 
==<span style="font-size: 11pt; font-family: 'Calibri','sans-serif'; color: #000000;">Dolphin CAD/CAM</span>==
See Forum Thread [https://www.dynomotion.com/forum/viewtopic.php?f=10&t=1743#p7371 here].
+
See Forum Thread [https://www.dynomotion.com/forum/viewtopic.php?f=10&t=1743#p7413 here].

Latest revision as of 12:46, 25 March 2024

Mechsoft

Hi Tom,
 
After much digging, I did find a post processor file in the Freemill site and it seems to work! 
 
Just an FYI:
The (freemill) instructions installing it were not accurate so if you run into this in the future the processor is downloaded at :
 
And then the file is installed into
C:\ProgramData\MecSoft Corporation\VisualCAM 2014\Posts\MILL
 
Thanks for your rapid reply!
 
Troy

AutoDesk Fusion 360

See this post

https://forums.autodesk.com/t5/fusion-360-computer-aided/tool-parameters/td-p/5711808


Also this post

http://www.cnczone.com/forums/dynomotion-kflop-kanalog/343726-posprocessor-fusion360-kflop.html#post2086576


Alexander (Александр Украинец) contributed two Posts.  One for Mill and one for Lathe (the .txt extension should be removed)

Fusion_360_KFLOP_Mill.cps.txt

Fusion360_KFLOP_Turning.cps.txt

Fusion360_KFLOP_Turning_Rev2.cps.txt (Added thread cutting G32)


mirocha posted this file on cnczone

KMotionCNC Fusion Post Processor

Post Processor for Fusion 360, I built a DIY 3 axia router, built to mill aluminum, 40 mm anti backlash ball screws, 3 hp spindle, stout machine. My programing computer hard drive crashed, new hard drive and reloaded Fusion 360 took hours to find the post processor file I was using and has worked for a few years with no problems. Below is the post processor for fusion 360 that I use. In my case I zero the XYZ to the piece, I do not have a tool changer, when I create the g code in Fusion 360 I create the g code for each tool separately, run the program, manually change the tool and run the next program for the next tool. This has worked great for me.

If your a DIY and need a post processor for fusion 360 this one works for Kflop/Kmotion, What I did was made a copy of one of the fusion 360 stock .cps files that are in fusion 360, open the KmotionCNC.pdf in notepad copy what is in the pdf over the stock .cps file and renamed it KmotionCNC

BobCAD

See Forum Thread here.

Dolphin CAD/CAM

See Forum Thread here.