|
Function |
Parameter |
Specification |
|
Analog |
DAC Outputs
ADC Inputs |
(8) +/- 10V @ 10ma, recommended load >2Kohm 12 bit - update rate 11.1KHz all 8 channels
(8) +/- 10V 100Kohm input Impedance 12 bit - update rate 11.1KHz all 8 channels |
|
Optos |
Opto Isolated Outputs
Opto Isolated Inputs |
(8) Max differential voltage 80V 25ma
(8) 3-24V input, internal 10KOhm series resistor |
| Differential | Differential Input Receivers |
(16) ANSI TIA/EIA-422-B, ANSI TIA/EIA-423-B +/-7V common mode range, 200mv sensitivity Internal 470ohm termination |
| Relay Drivers | N channel FET Switches |
(8) 24V @ 1 Amp max Open Drain switches to ground |
| Digital I/O | GPIO - LVTTL |
(8) Outputs Source/Sink 12ma (8) Inputs LVTTL, 3.3V 1µa max |
|
±15V |
On-board DC-DC Generator |
2 Watts (70ma each supply) |
| RS232 | Driver/Receiver |
EIA/TIA-232-F |
| Terminal Strips | Screw Terminals |
112 Pluggable Screw Terminals (7) x 16 pin 5mm pitch |
| Watchdog | Charge Pump |
DSP communication enables (1) Relay Driver, FET Switch 24V @ 1A
|
|
Logic Supply |
Voltage Typical Current |
+5V ±10% 0.5 A |
|
Environment |
Operating Temperature |
0-40º C
0-40º C |
|
Dimensions |
Length Width Height |
8.5 inches (216mm) 7.0 inches (178 mm) 0.75inches (19 mm) |
| Green | RoHS | Compliant |